Enterasys SecureStack C2

ip pimsm
SecureStack C2 Configuration Guide 17-45
PIM‐SMdeterminesthenetworktopologyusingtheunderlyingunicastroutingprotocoltobuild
aMulticastRoutingInformationBase(MRIB).
Commands
ip pimsm
ThiscommandsetsadministrativemodeofPIM‐SMmulticastroutingacrosstherouterto
enabled.IGMPmustbeenabledbeforePIM‐SMcanbeenabled.Bydefault,bothIGMPandPIM
aregloballydisabled.ThenoformofthiscommanddisablesPIM(acrosstheentirestack,if
applicable).
Syntax
ip pimsm
no ip pimsm
Parameters
None.
Defaults
None.
Mode
Globalrouterconfiguration:C2(su)‐>router(Config)#
Note: IGMP must be enabled on all VLANs running PIM-SM, and must also be globally enabled
on the SecureStack C2. For details on enabling IGMP, refer to Chapter 11.
For information about... Refer to page...
Global configuration commands
ip pimsm 17-45
ip pimsm staticrp 17-46
Interface configuration commands
ip pimsm enable 17-46
ip pimsm query-interval 17-47
Display commands
show ip pimsm 17-47
show ip pimsm componenttable 17-48
show ip pimsm interface 17-49
show ip pimsm neighbor 17-51
show ip pimsm rp 17-51
show ip pimsm rphash 17-53
show ip pimsm staticrp 17-53