Enterasys SecureStack C2 User Manual

Configuring Access Lists
18-70 Security Configuration
Defaults
Ifreinitializeisnotspecified,theusermustsupplySSHauthenticationkeyvalues.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoregenerateSSHkeys:
C2(su)->set ssh hostkey reinitialize
Configuring Access Lists
Purpose
Toreviewandconfiguresecurityaccesscontrollists(ACLs),whichpermitordenyaccessto
routinginterfacesbasedonprotocolandIPaddressrestrictions.
Commands
show access-lists
UsethiscommandtodisplayconfiguredIPaccesslistswhenoperatinginroutermode.
Syntax
showaccess‐lists[number]
Parameters
Router: These commands can be executed when the device is in router mode only. For details
on how to enable router configuration modes, refer to “Enabling Router Configuration Modes” on
page 15-2.
Note: Access Control Lists are limited to 100 per stack and 9 per interface on C2 stack
configurations, or mixed configurations of C2 and C3 switches in a stack. On C3-only
configurations, up to 100 Access Control Lists with up to 20 access rules per list and 60 per
interface are supported per stack .
For information about... Refer to page...
show access-lists 18-70
access-list (standard) 18-74
access-list (extended) 18-73
ip access-group 18-74
access‐list‐
number
(Optional)Displaysaccesslistinformationforaspecificaccesslistnumber.
Validvaluesarebetween1and199.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English