Enterasys SecureStack C2 User Manual

set ciscodp status
SecureStack C2 Configuration Guide 4-9
set ciscodp status
UsethiscommandtoenableordisabletheCiscodiscoveryprotocolgloballyontheswitch.
Syntax
set ciscodp state {auto | disable | enable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtogloballyenableCiscoDP:
C2(su)->set ciscodp state enable
set ciscodp timer
UsethiscommandtosetthenumberofsecondsbetweenCiscodiscoveryprotocolPDU
transmissions.
Syntax
set ciscodp timer seconds
Parameters
Defaults
None.
trusted The trust mode of the port. Default of trusted can be changed using the set ciscodp
port command.
cos The Class of Service priority value for untrusted traffic. The default of 0 can be
changed using the set ciscodp port command.
Table 4-3 show ciscodp port info Output Details (Continued)
Output What It Displays...
auto GloballyenableonlyifCiscoDPPDUsarereceived.
disable GloballydisableCiscodiscoveryprotocol.
enable GloballyenableCiscodiscoveryprotocol.
seconds SpecifiesthenumberofsecondsbetweenCiscoDPPDUtransmissions.
Validvaluesarefrom5to254seconds.

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English