Enterasys SecureStack C2 User Manual

Configuring Power over Ethernet (PoE)
SecureStack C2 Configuration Guide 3-27
Configuring Power over Ethernet (PoE)
Purpose
ToreviewandsetPoEparam eters,includingthepoweravailabletothesystem,theusage
thresholdforeachmodule,whetherornotSNMPtrapmessageswillbesentwhenpowerstatus
changes,andper‐portPoEsettings.
Commands
ThecommandsusedtoreviewandsetPoEportparametersarelistedbelow.
show inlinepower
UsethiscommandtodisplayswitchPoEproperties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Important Notice
This section applies only to PoE-equipped SecureStack C2 devices. Consult the Installation Guide shipped
with your product to determine if it is PoE-equipped.
For information about... Refer to page...
show inlinepower 3-27
set inlinepower threshold 3-28
set inlinepower trap 3-28
show port inlinepower 3-29
set port inlinepower 3-29

Enterasys SecureStack C2 Specifications

General

Brand	Enterasys
Model	SecureStack C2
Category	Switch
Language	English