Enterasys SecureStack C2

show dhcp binding
SecureStack C2 Configuration Guide 14-9
Example
Thisexampleresetsthenumberofpingpacketssentbacktothedefaultvalue.
C2(rw)->clear dhcp ping packets
show dhcp binding
UsethiscommandtodisplaybindinginformationforoneorallIPaddresses.
Syntax
show dhcp binding [ip-address]
Parameters
Defaults
IfnoIPaddressisspecified,bindinginformationforalladdressesisdisplayed.
Mode
Read‐only.
Example
Thisexampledisplaysbindinginformationaboutalladdresses.
C2(rw)->show dhcp binding
IP address Hardware Address Lease Expiration Type
----------- ----------------- ----------------- -----
192.0.0.6 00:33:44:56:22:39 00:11:02 Automatic
192.0.0.8 00:33:44:56:22:33 00:10:22 Automatic
192.0.0.10 00:33:44:56:22:34 00:09:11 Automatic
192.0.0.11 00:33:44:56:22:35 00:10:05 Automatic
192.0.0.12 00:33:44:56:22:36 00:10:30 Automatic
192.0.0.13 00:33:44:56:22:37 infinite Manual
192.0.0.14
00:33:44:56:22:38 infinite Manual
clear dhcp binding
Usethiscommandtoclear(delete)oneorallDHCPaddressbindings.
Syntax
clear dhcp binding {ip-addr | *}
Parameters
Defaults
None.
ip‐address (Optional)SpecifiestheIPaddressforwhichtodisplaybinding
information.
ip‐addr SpecifiestheIPaddressforwhichtoclear/deletetheDHCPbinding.
* Deletesalladdressbindings.