EasyManua.ls Logo

Enterasys SecureStack C2

Enterasys SecureStack C2
607 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ip pimsm query-interval
SecureStack C2 Configuration Guide 17-47
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
ThisexampleshowshowtoenablePIMonIPinterfaceforVLAN1.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm enable
ip pimsm query-interval
Thiscommandconfiguresthetransmissionfrequencyofhellomessagesinsecondsbetween
PIM‐enabledneighbors.Thenoformofthiscommandresetsthehellointervaltothedefault,30
seconds.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
Parameters
Defaults
None.
Mode
Interfaceconfiguration:C2(su)‐>router(Config‐if(Vlan1))#
Example
Thisexampleshowshowtosetthehellointervalrateto100seconds.
C2(su)->router(Config)#interface vlan 1
C2(su)->router(Config-if(Vlan 1))#ip pimsm query-interval 100
show ip pimsm
Usethiscommandtodisplaysystem‐widePIM‐SMroutinginformation.
Syntax
show ip pimsm
Parameters
None.
Defaults
None.
seconds Thisfieldhasarangeof10to3600seconds.Defaultis30.

Table of Contents

Related product manuals