Enterasys SecureStack C2 - Show Port Status

show port status
5-4 Port Configuration
Syntax
show port [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,operationalstatusinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplayoperationalstatusinformationforge.3.14:
C2(su)->show port ge.3.14
Port ge.3.14 enabled
show port status
Usethiscommandtodisplayoperatingandadminstatus,speed,duplexmodeandporttypefor
oneormoreportsonthedevice.
Syntax
show port status [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,statusinformationforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaystatusinformationforge.3.14:
C2(su)->show port status ge.3.14
Port Alias Oper Admin Speed Duplex Type
(truncated) Status Status
------------ -------------- ------- ------- -------- ------- -------------
ge.3.14 up up N/A N/A BaseT RJ45
Table 5‐1providesanexplanationofthecommandoutput.
port‐string (Optional)Displaysop erationalstatusforspecificport(s).Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage5‐2.
port‐string (Optional)Displaysstatusforspecificport(s).Foradetaileddescriptionof
possibleport‐stringvalues,referto“PortStringSyntaxUsedintheCLI”on
page5‐2.