Factory Default Settings
SecureStack C2 Configuration Guide 1-5
Area NSSA (OSPF) None configured.
Area range (OSPF) None configured.
Authentication key (RIP
and OSPF)
None configured.
Authentication mode (RIP
and OSPF)
None configured.
Dead interval (OSPF) Set to 40 seconds.
Disable triggered updates
(RIP)
Triggered updates allowed.
Distribute list (RIP) No filters applied.
DVMRP Disabled. Metric set to 1.
Hello interval (OSPF) Set to 10 seconds for broadcast and point-to-point networks. Set to 30
seconds for non-broadcast and point-to-multipoint networks.
ICMP Enabled for echo-reply and mask-reply modes.
IP-directed broadcasts Disabled.
IP forward-protocol Enabled with no port specified.
IP interfaces Disabled with no IP addresses specified.
IRDP Disabled on all interfaces. When enabled, maximum advertisement interval is
set to 600 seconds, minimum advertisement interval is set to 450 seconds,
holdtime is set to 1800 seconds, and address preference is set to 0.
MD5 authentication
(OSPF)
Disabled with no password set.
MTU size Set to 1500 bytes on all interfaces.
OSPF Disabled.
OSPF cost Set to 10 for all interfaces.
OSPF network None configured.
OSPF priority Set to 1.
Passive interfaces (RIP) None configured.
Proxy ARP Enabled on all interfaces.
Receive interfaces (RIP) Enabled on all interfaces.
Retransmit delay (OSPF) Set to 1 second.
Retransmit interval (OSPF) Set to 5 seconds.
RIP receive version Set to accept both version 1 and version 2.
RIP send version Set to version 1.
RIP offset No value applied.
SNMP Enabled.
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Table 1-1 Default Settings for Basic Switch and Router Operation (Continued)
Feature Default Setting
To Next Page
Loading...
Need help?
General