Index
ATM Services Configuration Guide for CBX 3500, CBX 500, GX 550, and B-STDX 9000 Index-11
Beta Draft Confidential
PNNI/VNN OSPF call interworking, 21-17
RCC traffic descriptors, 12-16
routing protocol, 21-8
signaling overview, 21-14
supported features, 21-8
suppress PNNI advertisement, 17-39
trap support, 21-56
UBR load balancing, 21-14
using management SPVCs, 11-11
Protocol timers
Q.93B signaling, 17-14
Proxy signaling
overview, 16-18
PSA, 16-19
PSC, 16-20
PSAX device
adding to the map, 7-42
Pseudo wire, 9-5
PVC Establishment Rate Control, 10-5
with VC Overload Control disabled, 10-5
with VC Overload Control enabled, 10-5
PVC redirect, 10-34
PVC, see permanent virtual circuit
PWE3 over MPLS
overview, 9-5
supported modules, 9-5
Q
Q.93B signaling, 17-13 to 17-15
maximum restarts, 17-14
protocol timers, 17-14
Q.SAAL
thresholds, 17-15
QoS
setting
attributes, 3-51, 9-23
Quality of Service (QoS)
for SVCs, 3-56
parameters, 10-55
setting for logical ports, 3-51
R
Rate Decrease Factor (RDF), 5-14
Rate enforcement, 10-45
Rate Increase Factor (RIF), 5-14
Rate profile tables, 6-8
description of, 5-15
determining values, D-2
Rate Decrease Exponent (RDE), 5-15
Rate Increase Exponent (RIE), 5-15
Redirect PVCs
described, 10-34
Reject delay, 17-6
Reliable Scalable Circuit
described, 10-8
error messages, F-1
Remote gateway address
setting, 17-49
Reroute time tuning
enabling on PMP circuits, 10-78
enabling on PVCs, 10-29, 10-62
Resilient Link Management Interface (RLMI)
configuration sequence, 15-5
configuring logical ports for, 1-4, 15-1, 15-2
fields
LPort Type, 15-6
FRF.4 support, 15-2
Resilient UNI
with APS, 14-9
Resilient UNI/APS Resilient UNI over PNNI,
21-25 to 21-26
Resilient UNI/NNI, 14-1
Restricted priority routing, 10-29
RFC 1483 to 1490, 10-64
RFC 1490 to 1483, 10-64
RLMI, see Resilient Link Management Interface
RM cells
generation, 5-6
Routing determination
SVCs, 16-10
Routing metrics, 3-54
administrative cost, 3-54
cell delay variation, 3-54
RSVP-TE
configuring, 9-34 to 9-38
To Next Page
Loading...
