RM0390 Rev 4 437/1328
RM0390 Digital camera interface (DCMI)
448
Bit 7 VSPOL: Vertical synchronization polarity
This bit indicates the level on the DCMI_VSYNC pin when the data are not valid
on the parallel interface.
0: DCMI_VSYNC active low
1: DCMI_VSYNC active high
Bit 6 HSPOL: Horizontal synchronization polarity
This bit indicates the level on the DCMI_HSYNC pin when the data are not valid
on the parallel interface.
0: DCMI_HSYNC active low
1: DCMI_HSYNC active high
Bit 5 PCKPOL: Pixel clock polarity
This bit configures the capture edge of the pixel clock
0: Falling edge active.
1: Rising edge active.
Bit 4 ESS: Embedded synchronization select
0: Hardware synchronization data capture (frame/line start/stop) is synchronized
with the DCMI_HSYNC/DCMI_VSYNC signals.
1: Embedded synchronization data capture is synchronized with synchronization
codes embedded in the data flow.
Note: Valid only for 8-bit parallel data. HSPOL/VSPOL are ignored when the ESS
bit is set.
This bit is disabled in JPEG mode.
Bit 3 JPEG: JPEG format
0: Uncompressed video format
1: This bit is used for JPEG data transfers. The DCMI_HSYNC signal is used as
data enable. The crop and embedded synchronization features (ESS bit) cannot
be used in this mode.
Bit 2 CROP: Crop feature
0: The full image is captured. In this case the total number of bytes in an image
frame should be a multiple of 4
1: Only the data inside the window specified by the crop register will be captured.
If the size of the crop window exceeds the picture size, then only the picture size
is captured.
Bit 1 CM: Capture mode
0: Continuous grab mode - The received data are transferred into the destination
memory through the DMA. The buffer location and mode (linear or circular
buffer) is controlled through the system DMA.
1: Snapshot mode (single frame) - Once activated, the interface waits for the
start of frame and then transfers a single frame through the DMA. At the end of
the frame, the CAPTURE bit is automatically reset.
To Next Page
Loading...
Need help?
General
