AT-9000 Switch Command Line User’s Guide
1025
NO SNMP-SERVER HOST
Syntax
no snmp-server host
ipaddress
traps|informs version 1|2c
community_string
Parameters
ipaddress
Specifies the IPv4 or IPv6 address of a trap or inform receiver to be
removed from a community string. You can specify only one IP
address.
traps|informs
Specifies the type of messages the switch is sending to the
receiver.
1|2c
Specifies the format of the messages that the switch is transmitting
to the receiver. You can specify only 2c when you are deleting the
IP address of an inform message receiver.
community_string
Specifies the SNMP community string to which the IP address of
the trap or inform receiver is assigned. This parameter is case
sensitive.
Mode
Global Configuration mode
Description
Use this command to remove IP addresses of trap or inform receivers from
the community strings on the switch. You can remove only one receiver at
a time with this command. The switch does not send any further SNMP
trap or inform messages to network devices after their IP addresses have
been deleted from the community strings.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
To Next Page
Loading...
Need help?
General
