Allied Telesis AT-9000 Series - No Lldp Med-Tlv-Select

AT-9000 Switch Command Line User’s Guide
1157
NO LLDP MED-TLV-SELECT
Syntax
no lldp med-tlv-select capabilities|network-
policy|location|power-management-ext|inventory-
management|all
Parameters
capabilities
Specifies the capabilities TLV.
network-policy
Specifies the network policy TLV.
location
Specifies the location identification TLV.
power-management-ext
Specifies the extended power-via-MDI TLV.
inventory-management
Specifies the inventory management TLV.
all
Configures a port to stop sending all LLDP-MED TLVs.
Mode
Port Interface mode
Description
Use this command to stop ports from transmitting LLDP-MED TLVs. You
can specify only one TLV per command. The default setting is for ports to
send all optional LLDP-MED TLVs, except for the inventory TLV.
Confirmation Command
“SHOW LLDP INTERFACE” on page 1167