EasyManuals Logo

Allied Telesis AT-9000 Series User Manual

Allied Telesis AT-9000 Series
1526 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1161 background imageLoading...
Page #1161 background image
AT-9000 Switch Command Line User’s Guide
1161
NO LLDP TLV-SELECT
Syntax
no lldp tlv-select
all|tlv
Parameters
all
Removes all optional LLDP TLVs from a port.
tlv
Removes an optional TLV from a port. You can specify only one
TLV. To remove more than one TLV from a port, repeat the
command as many times as needed.
Mode
Port Interface mode
Description
Use this command to stop ports from sending optional LLDP TLVs to their
neighbors. The optional TLVs are listed in Table 102 on page 1144.
To stop ports from transmitting LLDP-MED TLVs, refer to “NO LLDP MED-
TLV-SELECT” on page 1157.
Confirmation Command
“SHOW LLDP INTERFACE” on page 1167
Examples
This example configures ports 21 and 22 to stop transmitting all optional
LLDP TLVs:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21,port1.0.22
awplus(config-if)# no lldp tlv-select all
This example stops the transmission of the management-address and
system-capabilities TLVs on port 11:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11
awplus(config-if)# no lldp tlv-select management-address
awplus(config-if)# no lldp tlv-select system-capabilities

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-9000 Series and is the answer not in the manual?

Allied Telesis AT-9000 Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-9000 Series
CategorySwitch
LanguageEnglish

Related product manuals