EasyManuals Logo

Allied Telesis AT-9000 Series User Manual

Allied Telesis AT-9000 Series
1526 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1029 background imageLoading...
Page #1029 background image
AT-9000 Switch Command Line User’s Guide
1029
SHOW RUNNING-CONFIG SNMP
Syntax
show running-config snmp
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the SNMPv1 and SNMPv2c community
strings and the IP addresses of trap and inform receivers. An example is
shown in Figure 176.
Figure 176. SHOW RUNNING-CONFIG SNMP Command
Example
This example displays the SNMPv1 and SNMPv2c community strings and
the IP addresses of trap and inform receivers:
awplus# show running-config snmp
snmp-server
no snmp-server enable trap auth
snmp-server community sw12eng1 rw
snmp-server community sw12eng1limit rw
snmp-server community westplnm7 ro
snmp-server community site12pl4 ro
snmp-server host 149.198.74.143 traps version 2c sw12eng1
snmp-server host 149.198.74.154 traps version 2c sw12eng1
snmp-server host 149.198.121.17 traps version 2c sw12eng1limit
snmp-server host 149.198.121.198 traps version 2c sw12eng1limit

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-9000 Series and is the answer not in the manual?

Allied Telesis AT-9000 Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-9000 Series
CategorySwitch
LanguageEnglish

Related product manuals