AT-9000 Switch Command Line User’s Guide
265
NO SNMP-SERVER ENABLE TRAP POWER-INLINE
Syntax
no snmp-server enable trap power-inline
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable the transmission of SNMP power-inline
traps. The switch sends this trap if the power requirements of the switch
and PDs exceed the threshold set with “POWER-INLINE USAGE-
THRESHOLD” on page 272
Confirmation Command
“SHOW RUNNING-CONFIG SNMP” on page 1029
Example
The following example disables the SNMP power-inline trap:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server enable trap power-inline
To Next Page
Loading...
