Chapter 77: Quality of Service (QOS) Commands
1312 Section X: Network Management
MLS QOS MAP COS-QUEUE
Syntax
mls qos map cos-queue cos_
priority
to
egress_queue
Parameters
cos_priority Specifies a Class of Service (CoS) priority level of 0, lowest
priority, through 7, highest priority. An egress queue can
have more than one priority level, but you can specify just
one priority level at a time with this command.
egress_queue Specifies an egress queue number of 0 through 7, The
lowest priority queue is 0 and the highest queue is 7. You
can specify just one queue.
Mode
Port Interface mode
Description
Use this command to map CoS priorities to port egress queues. An egress
queue can have more than one priority, but you can assign just one
priority at a time with this command.
QoS must be enabled on the switch and a port must be set to CoS
trust before you can use this command. Refer to commands “MLS
QOS ENABLE” on page 1311 and “MLS QOS TRUST COS” on
page 1319.
Use the NO form of this command to return the CoS priority mappings on
ports to their default values.
Confirmation Command
“SHOW MLS QOS MAPS COS-QUEUE” on page 1326
Examples
This example maps priorities 1 and 2 to queue 5 and priority 3 to queue 6
on port 18:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.18
To Next Page
Loading...
Need help?
General
