AT-9000 Switch Command Line User’s Guide
239
SPEED
Syntax
speed auto|10|100|1000
Parameters
auto
Activates Auto-Negotiation so that the speed is configured
automatically.
10
Specifies 10 Mbps.
100
Specifies 100 Mbps.
1000
Specifies 1000 Mbps. This setting should not be used on twisted
pair ports. For 1000Mbps, full duplex operation, a twisted pair port
must be set to Auto-Negotiation.
Mode
Port Interface mode
Description
Use this command to manually set the speeds of the twisted pair ports or
to activate Auto-Negotiation.
Confirmation Commands
Configured speed: “SHOW INTERFACE STATUS” on page 227
Current operating speed: “SHOW INTERFACE” on page 221
Examples
This example sets the speed on ports 11 and 17 to 100 Mbps:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11,port1.0.17
awplus(config-if)# speed 100
To Next Page
Loading...
Need help?
General
