Allied Telesis AT-9000 Series User Manual

Chapter 76: ACL Commands
1304
NO ACCESS-GROUP
Syntax
no access-group id_number
Parameters
id_number
Specifies the ID number of an access list. The range is 3000 to
3699. You can remove one ACL from a port at a time with this
command.
Mode
Port Interface mode
Description
Use this command to remove ACLs from ports on the switch. This
command works for all ACLs, except for MAC address ACLs, which are
removed with “NO MAC ACCESS-GROUP” on page 1305.
Confirmation Command
“SHOW INTERFACE ACCESS-GROUP” on page 1308
Example
This example removes the ACL with the ID number 3121 from port 23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# no access-group 3121
awplus(config-if)# end
awplus# show interface port1.0.23 access-group

Allied Telesis AT-9000 Series Specifications

General

Brand	Allied Telesis
Model	AT-9000 Series
Category	Switch
Language	English