AT-9000 Switch Command Line User’s Guide
547
COPY FLASH TFTP
Syntax
copy flash tftp
ipaddress filename
Parameters
ipaddress
Specifies the IP address of a TFTP server on your network.
filename
Specifies the filename of a configuration file to upload from the file
system in the switch to a TFTP server. The filename cannot
contain spaces and must include the extension “.cfg”. You can
specify one filename.
Mode
Privileged Exec mode
Description
Use this command to upload configuration files from the file system in the
switch to a TFTP server on your network. You can perform the command
from a local management session or a remote Telnet or SSH management
session. For instructions on how to use this command, refer to “Uploading
Files from the Switch with TFTP” on page 537.
Example
This example uploads the configuration file “west_unit.cfg” from the file
system in the switch to a TFTP server that has the IP address
149.22.121.45:
awplus> enable
awplus# copy flash tftp 149.22.121.45
west_unit.cfg
To Next Page
Loading...
Need help?
General
