AT-9000 Switch Command Line User’s Guide
929
SHOW PORT-SECURITY INTRUSION INTERFACE
Syntax
show port-security intrusion interface
port
Parameter
port
Specifies a port. You can specify more than one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the number of packets the ports have had to
discard because the packets had unknown source MAC addresses. The
ports begin to discard packets after learning their maximum number of
source MAC addresses. This information is also available with “SHOW
PORT-SECURITY INTERFACE” on page 926.
Figure 158 provides an example of the information.
Figure 158. SHOW PORT-SECURITY INTRUSION INTERFACE
Command
Example
This command displays the number of discarded packets on port 15:
awplus# show port-security intrusion interface port1.0.15
Figure 159 on page 930 is an example of the information.
Port Security Intrusion List
--------------------------------------------------------
Interface: Port 1.0.4 - 122 intrusion(s) detected
To Next Page
Loading...
Need help?
General
