Allied Telesis AT-9000 Series - Creating New Aggregators

AT-9000 Switch Command Line User’s Guide
611
Creating New Aggregators
To create a new aggregator, move to the Port Interface mode of the
aggregator’s member ports and issue the CHANNEL-GROUP command,
which has this format:
channel-group id_number
The ID_NUMBER parameter has a range of 1 to 32. Each aggregator
must be assigned a unique ID number.
If the ports of a new aggregator are already members of other
aggregators, the switch automatically removes them from their current
assignments before adding them to the new aggregator.
Caution
To avoid creating a loop in your network topology, do not connect
the network cables to the ports until after you have created the
aggregator with the CHANNEL-GROUP command.
These commands create a new aggregator of ports 11 and 12, with the ID
number 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.11-port1.0.12
awplus(config-if)# channel-group 4