Chapter 52: GARP VLAN Registration Protocol Commands
834
NO GVRP TIMER JOIN
Syntax
no gvrp timer join
Parameters
None
Mode
Global Configuration mode
Description
Use this command to disable GVRP Join Timer configurations and return
the GVRP Join Timer to its default value. This timer must only be disabled
in relation to the GVRP Leave Timer according to the following equation:
Join Timer <= (2 x (GVRP Leave Timer))
The setting for this timer must be the same on all GVRP-active
network devices.
Example
This command sets the Join Timer to 0.2 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# no gvrp timer join
To Next Page
Loading...
