433
Chapter 22
Enhanced Stacking Commands
The enhanced stacking commands are summarized in Table 37.
Table 37. Enhanced Stacking Commands
Command Mode Description
“ESTACK COMMAND-SWITCH” on
page 435
Global
Configuration
Designates the switch as the
command switch.
“ESTACK RUN” on page 436 Global
Configuration
Activates enhanced stacking on the
switch.
“NO ESTACK COMMAND-SWITCH”
on page 437
Global
Configuration
Returns the switch to the state of
being a member switch.
“NO ESTACK RUN” on page 438 Global
Configuration
Disables enhanced stacking on the
switch.
“RCOMMAND” on page 439 Global
Configuration
Redirects the management session to
a different switch in the enhanced
stack.
“REBOOT ESTACK MEMBER” on
page 440
Global
Configuration
Reboots member switches of an
enhanced stack from the command
switch.
“SHOW ESTACK” on page 442 Privileged Exec Displays whether the switch is a
command or member switch and
whether enhanced stacking is enabled
or disabled.
“SHOW ESTACK COMMAND-
SWITCH” on page 444
Privileged Exec Displays enhanced stacking
information about the command
switch from a member switch.
“SHOW ESTACK REMOTELIST” on
page 445
Privileged Exec Displays the switches of an enhanced
stack.
“UPLOAD CONFIG REMOTELIST” on
page 447
Global
Configuration
Uploads boot configuration files from
the file system in the command switch
of an enhanced stack to the member
switches.
To Next Page
Loading...
Need help?
General
