Allied Telesis AT-9000 Series - Show Baud-Rate; Figure 36: SHOW BAUD-RATE Command

Chapter 8: Basic Switch Management Commands
156
SHOW BAUD-RATE
Syntax
show baud-rate
Parameters
None
Mode
User Exec mode and Privileged Exec mode
Description
Use this command to display the settings of the Console port, used for
local management sessions of the switch. Here is an example of the
information.
Figure 36. SHOW BAUD-RATE Command
To set the baud rate, refer to “BAUD-RATE SET” on page 139.
Note
The baud rate is the only adjustable parameter on the Console port.
Example
This example displays the settings of the console port:
awplus# show baud-rate
Asynchronous Port (Console) Information:
Baud Rate .................... 9600
Parity ....................... User Configured
Data bits .................... 0
Stop bits .................... 1