AT-9000 Switch Command Line User’s Guide
603
SHOW STATIC-CHANNEL-GROUP
Syntax
show static-channel-group
Parameters
None
Modes
User Exec mode and Privileged Exec mode
Description
Use this command to display the member ports of static port trunks on the
switch. An example of the command is shown in Figure 108.
Figure 108. SHOW STATIC-CHANNEL-GROUP Command
To view the load distribution methods of static port trunks, display the
running configuration with “SHOW RUNNING-CONFIG” on page 158.
Example
This example displays the member ports of a static port trunk:
awplus# show static-channel-group
% Static Aggregator: sa1
% Member:
port1.0.5
port1.0.6
port1.0.7
% Static Aggregator: sa2
% Member:
port1.0.19
port1.0.20
port1.0.21
port1.0.22
To Next Page
Loading...
