EasyManuals Logo

Allied Telesis AT-9000 Series User Manual

Allied Telesis AT-9000 Series
1526 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #448 background imageLoading...
Page #448 background image
Chapter 22: Enhanced Stacking Commands
448
UPLOAD IMAGE REMOTELIST
Syntax
upload image remotelist
Parameters
None
Mode
Global Configuration mode
Description
Use this command to upload the management software on the command
switch of an enhanced stack to the member switches. The command
displays the following prompt:
Remote switches will reboot after load is complete...
Enter the list of switches ->
When you see this prompt, enter the enhanced stack numbers of the
member switches to receive the management software from the command
switch. You may update the management software on more than one
member switch at a time. To specify more than one switch, separate the
numbers with commas. To update all of the switches in the enhanced
stack, enter ALL. The numbers are viewed with the SHOW ESTACK
REMOTELIST command in the Privileged Exec mode.
Here are the steps of the file transfer between the command switch and a
member switch:
1. The command switch sends its management software to the member
switch over the Ethernet link of the common VLAN that connects the
switches of the enhanced stack.
2. After the member switch has received the entire file, it compares the
version numbers of the new management software from the command
switch and its current software.
3. If the version numbers are the same, the switch cancels the update
and discards the file.
4. If the version numbers are different, the member switch writes the file
to its flash memory. This phase may take up to one minute to
complete.
5. After the file is written to flash memory, the member switch resets.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-9000 Series and is the answer not in the manual?

Allied Telesis AT-9000 Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-9000 Series
CategorySwitch
LanguageEnglish

Related product manuals