Allied Telesis AT-9000 Series - Show Ipv6 Route; Figure 71: SHOW IPV6 ROUTE Command

AT-9000 Switch Command Line User’s Guide
321
SHOW IPV6 ROUTE
Syntax
show ipv6 route
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the IPv6 management address and default
gateway on the switch. Figure 71 is an example of the information. The
default route is display first, followed by the management address.
Figure 71. SHOW IPV6 ROUTE Command
Example
The following example displays the IPv6 management address and default
gateway:
awplus# show ipv6 route
IPv6 Routing Table
Codes: C - connected, S - static
S 0:0:0:0:0:0:0:0/0 via 832a:5821:b34a:0:0:0:187:14, vlan4-0
C 832a:5821:b34a:0:0:0:187:95a/64 via ::, vlan4-0