AT-9000 Switch Command Line User’s Guide
985
DOT1X PORT-CONTROL AUTO
Syntax
dot1x port-control auto
Parameters
None
Mode
Port Interface mode
Description
Use this command to set the ports to the 802.1x port-based authenticator
role. Ports begin in the unauthorized state, forwarding only EAPOL
frames, until a supplicant has successfully logged on. For background
information, refer to “Operational Settings for Authenticator Ports” on
page 942.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995 or “SHOW DOT1X
INTERFACE” on page 1000
Example
This example sets ports 1.0.7 to 1.0.10 to the authenticator role:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.7-port1.0.10
awplus(config-if)# dot1x port-control auto
To Next Page
Loading...
