EasyManuals Logo

Allied Telesis AT-9000 Series User Manual

Allied Telesis AT-9000 Series
1526 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #440 background imageLoading...
Page #440 background image
Chapter 22: Enhanced Stacking Commands
440
REBOOT ESTACK MEMBER
Syntax
reboot estack member
id_number
| all
Parameters
id_number
Specifies the enhanced stack ID number of a switch. The number
is displayed with “SHOW ESTACK REMOTELIST” on page 445.
You may specify the ID number of only one switch.
all
Specifies all of the switches of the enhanced stack, except the
command switch.
Mode
Global Configuration mode
Description
Use this command from the command stack of an enhanced switch to
reboot member switches. You may reboot individual member switches or
all of the member switches of a stack. You must perform “SHOW ESTACK
REMOTELIST” on page 445 prior to this command to determine the ID
numbers of the switches.
Caution
A switch does not forward network traffic when it reboots and
initializes its management software. Some network traffic may be
lost. The reset can take from 10 seconds to two minutes, depending
on the number and complexity of the commands in the active boot
configuration file.
Note
Any configuration changes that are not saved to the active
configuration file with the WRITE command are discarded when a
switch reboots.
Caution
This command does not display a confirmation prompt. A member
switch resets as soon as you enter the command.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Allied Telesis AT-9000 Series and is the answer not in the manual?

Allied Telesis AT-9000 Series Specifications

General IconGeneral
BrandAllied Telesis
ModelAT-9000 Series
CategorySwitch
LanguageEnglish

Related product manuals