Chapter 63: 802.1x Port-based Network Access Control Commands
978
AUTH-MAC REAUTH-RELEARNING
Syntax
auth-mac reauth-relearning
Parameters
None
Mode
Port Interface mode
Description
Use this command to set the MAC address of the supplicant (client device)
to re-learning for re-authentication on the interface specified in the
INTERFACE command.
Example
This example sets the MAC address of the supplicant to re-learning for re-
authentication on port 1.0.23:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.23
awplus(config-if)# auth-mac reauth-relearning
To Next Page
Loading...
