AT-9000 Switch Command Line User’s Guide
1143
LLDP TIMER
Syntax
lldp timer
interval
Parameters
interval
Specifies the transmit interval. The range is 5 to 32768 seconds.
Mode
Global Configuration mode
Description
Use this command to set the transmit interval. This is the interval between
regular transmissions of LLDP advertisements. The transmit interval must
be at least four times the transmission delay timer, set with “LLDP TX-
DELAY” on page 1148.
Confirmation Command
“SHOW LLDP” on page 1165
Example
This example sets the transmit interval to 60 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# lldp timer 60
To Next Page
Loading...
