AT-9000 Switch Command Line User’s Guide
1131
LLDP LOCATION
Syntax
lldp location
civic-location-id|coord-location-id|elin-
location-i
d
location_id
Parameters
civic-location-id
Adds a civic location to the ports.
coord-location-id
Adds a coordinate location to the ports.
elin-location-idA
dds an ELIN location to the ports.
location-id
Specifies the ID number of the location information to be added to
the ports. You can add only one location at a time.
Mode
Port Interface mode
Description
Use this command to add LLDP-MED location information to the ports on
the switch. The same command is used to add civic, coordinate and ELIN
locations. The specified location entry must already exist.
To remove LLDP-MED location information from the ports, use the NO
form of this command. You do not have to specify ID numbers when
removing location entries from the ports.
Confirmation Command
“SHOW LOCATION” on page 1182.
Examples
This example adds the civic location ID 5 to ports 3 and 4:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.3,port1.0.4
awplus(config_if)# lldp location civic-location-id 5
To Next Page
Loading...
Need help?
General
