AT-9000 Switch Command Line User’s Guide
571
SHOW LOG TAIL
Syntax
show log tail [
number
]
Parameter
number
Specifies the number of event messages to display. The range is
10 to 250 messages. The default is 10 messages.
Mode
Privileged Exec mode
Description
Use this command to display the most recent event messages in the
buffered event log. The NUMBER parameter is used to specify the number
of messages to display. The messages are displayed from oldest to
newest. For an example and description of the log, refer to Figure 102 on
page 565 and Table 53 on page 565.
Examples
This example displays the 10 most resent event messages in the buffered
log. The messages are displayed from oldest to newest:
awplus# show log tail
This example displays the 30 most recent event messages:
awplus# show log tail 30
To Next Page
Loading...
Need help?
General
