Allied Telesis AT-9000 Series - Deleting IP Addresses of TACACS+ Servers; Displaying the TACACS+ Client; Figure 227: SHOW TACACS Command

Chapter 90: RADIUS and TACACS+ Clients
1446
Deleting IP
Addresses of
TACACS+
Servers
To delete the IP address of a TACACS+ server from the client on the
switch, use the NO TACACS-SERVER HOST command in the Global
Configuration mode. You can delete only one IP address at a time with
this command. This example removes the IP address 122.124.15.7 from
the TACACS+ client:
awplus> enable
awplus# configure terminal
awplus(config)# no tacacs-server host 122.114.15.7
Displaying the
TACACS+ Client
To display the settings of the TACACS+ client, use the SHOW TACACS
command in the Privileged Exec mode.
awplus# show tacacs
Here is an example of the TACACS+ client information.
Figure 227. SHOW TACACS Command
The fields are explained in Table 157 on page 1472.
TACACS+ Global Configuration
Timeout : 5 sec
Server Host/ Server
IP Address Status
-----------------------
10.0.0.170 Alive
192.168.1.166 Unknown