Chapter 63: 802.1x Port-based Network Access Control Commands
974
AUTH TIMEOUT REAUTH-PERIOD
Syntax
auth timeout reauth-period
value
Parameters
reauth-period
Specifies the time interval that an authenticator port requires a
supplicant to reauthenticate. The range is 1 to 65,535 seconds.
The default value is 3600 seconds.
Mode
Port Interface mode
Description
Use this command to specify the time interval for reauthentication of
supplicants on an authenticator port. Reauthentication must be enabled
on an authenticator port for the timer to work. Reauthentication on a port is
activated with “AUTH REAUTHENTICATION” on page 972.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995 or “SHOW DOT1X
INTERFACE” on page 1000
Example
This example activates reauthentication on port 1.0.16 and sets the
reauthentication interval to 12 hours:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.16
awplus(config-if)# auth reauthentication
awplus(config-if)# auth timeout reauth-period 43200
To Next Page
Loading...
Need help?
General
