Allied Telesis AT-9000 Series - Disabling GVRP Timers on the Switch

Chapter 51: GARP VLAN Registration Protocol
816
Disabling GVRP Timers on the Switch
To disable GVRP timer configurations, use the NO GVRP TIMER
commands in the Global Configuration mode. They are:
no gvrp timer join
no gvrp timer leave
no gvrp timer leaveall
Use these commands to reset GVRP timers to the default values for each
individual parameter. The default values are:
GVRP timer join: 20
GVRP timer leave: 60
GVRP timer leave all: 1000
For reference information, refer to “NO GVRP TIMER JOIN” on page 834,
“NO GVRP TIMER LEAVE” on page 835 and “NO GVRP TIMER
LEAVEALL” on page 836.