Allied Telesis AT-9000 Series - Help; Figure 34: HELP Command

Chapter 8: Basic Switch Management Commands
144
HELP
Syntax
help
Parameters
None
Mode
All modes
Description
Use this command to learn how to use on-line help. Entering this
command at a command line displays how to use the on-line help system.
See Figure 34 for the description displayed on the screen.
Figure 34. HELP Command
Example
This example displays the HELP command:
awplus# help
When you need help at the command line, press “?”.
If nothing matches, the help list will be empty. Delete
characters until entering a ‘?’ shows the available options.
Enter ‘?’ after a complete parameter to show remaining valid
command parameters (e.g. ‘show ?’).
Enter ‘?’ after part of a parameter to show parameters that
complete the typed letters (e.g. ‘show ip?’).