Allied Telesis AT-9000 Series - Show Tacacs; Figure 229: SHOW TACACS Command; Table 157. SHOW TACACS Command

Chapter 91: RADIUS and TACACS+ Client Commands
1472
SHOW TACACS
Syntax
show tacacs
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the configuration of the TACACS+ client on
the switch. An example of the information is shown in Figure 229.
Figure 229. SHOW TACACS Command
The fields are described in Table 157.
Table 157. SHOW TACACS Command
Parameter Description
Timeout The length of the time, in seconds, that
the switch waits for a response from a
TACACS+ server to an authentication
request. The default is 40 seconds. If
there is no response from any
authentication servers, the switch
reactivates the local manager accounts.
This parameter cannot be changed.
Server Host The IP address of a TACACS+ server on
your network.
TACACS+ Global Configuration
Timeout : 5 sec
Server Host : 149.123.154.12
Server Status : Alive
Server Host : 149.123.154.26
Server Status : Dead