Allied Telesis AT-9000 Series User Manual

AT-9000 Switch Command Line User’s Guide
1077
Displaying the sFlow Agent
To view the IP addresses and UDP port settings of the collectors as
defined in the sFlow agent on the switch, use the SHOW SFLOW
command in the Global Configuration mode. Here is the command:
awplus(config)# show sflow
Here is an example of the display.
Figure 181. SHOW SFLOW Command
The fields are described in Table 94 on page 1091.
Number of Collectors: 1
Collector_address UDP_port
================== ========
149.122.78.12 6343
Number of Samplers/Pollers 4
Port Sample-rate Polling-interval
==== =========== ================
1.0.4 1000 60
1.0.12 1000 60
1.0.13 50000 2400
1.0.14 50000 2400
sFlow Status
============
Enabled

Allied Telesis AT-9000 Series Specifications

General

Brand	Allied Telesis
Model	AT-9000 Series
Category	Switch
Language	English