Chapter 10: Port Parameter Commands
202
EGRESS-RATE-LIMIT
Syntax
egress-rate-limit
value
Parameters
value
Specifies the maximum amount of traffic that can be transmitted
from the port. The value is kilobits per second. The range is 64 to
1,000,000 kilobits per second.
Mode
Port Interface mode
Description
Use this command to set a limit on the amount of traffic that can be
transmitted per second from the port.
Confirmation Command
“SHOW RUNNING-CONFIG” on page 158
Example
This example sets the egress rate limit to 1,000,000 kilobits per second on
ports 15, 16 and 21:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.15,port1.0.16,port1.0.21
awplus(config-if)# egress-rate-limit 1000000
To Next Page
Loading...
