AT-9000 Switch Command Line User’s Guide
957
Configuring Reauthentication
Table 87 lists the commands in the Port Interface mode for configuring
reauthentication on authenticator ports. Reauthentication causes
authenticator ports to periodically re-initiate authentication of supplicants.
This is an additional security feature that protects your network by having
supplicants periodically repeat the authentication process.
This example activates reauthentication on authenticator ports 1.0.21 and
1.0.22 so that the supplicants must reauthenticate every 2 hours (7200
seconds):
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21,port1.0.22
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth reauthentication
awplus(config-if)# auth timeout reauth-period 7200
This example deactivates reauthentication on port 1.0.21:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21
awplus(config-if)# no auth reauthentication
Table 87. Reauthentication Commands
To Use This Command Range
Activate reauthentication so that
supplicants must periodically
reauthenticate.
AUTH REAUTHENTICATION -
Specify the time interval for
reauthentication.
AUTH TIMEOUT REAUTH-PERIOD
value
1 to 65,535
seconds
Remove reauthentication from ports. NO AUTH REAUTHENTICATION -
To Next Page
Loading...
Need help?
General
