Chapter 31: Boot Configuration File Commands
524
COPY RUNNING-CONFIG
Syntax
copy running-config
filename
.cfg
Parameter
filename
Specifies a name for a new boot configuration file. The name can
be from 1 to 16 alphanumeric characters. The extension must be
“.cfg”.
Mode
Privileged Exec mode
Description
Use this command to create new boot configuration files. Stored in the file
system on the switch, the files contain the current settings of the switch.
You might use this command to create a backup copy of the switch’s
current configuration.
This command does not change the active boot configuration file. To
designate a different file as the active boot configuration file on the switch,
refer to “BOOT CONFIG-FILE” on page 522.
Confirmation Command
“DIR” on page 511
Example
This example creates a new boot configuration file called
“salesunit2_archive.cfg”.
awplus> enable
awplus# copy running-config salesunit2_archive.cfg
To Next Page
Loading...
Need help?
General
