AT-9000 Switch Command Line User’s Guide
1305
NO MAC ACCESS-GROUP
Syntax
no mac access-group
id_number
Parameters
id_number
Specifies the ID number of a MAC address access list to be
removed from a port. The range is 4000 to 4699 You can remove
one ACL from a port at a time with this command.
Mode
Port Interface mode
Description
Use this command to remove MAC address ACLs from ports on the
switch.
Confirmation Command
“SHOW INTERFACE ACCESS-GROUP” on page 1308
Example
This example removes a MAC address ACL with the ID number 4014 from
port 16:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.16
awplus(config-if)# no mac access-group 4014
awplus(config-if)# end
awplus# show interface port1.0.16 access-group
To Next Page
Loading...
