AT-9000 Switch Command Line User’s Guide
461
MIRROR INTERFACE
Syntax
mirror interface
source_ports
direction
receive|transmit|both
Parameters
source_ports
Specifies a source port for the port mirror. You can specify more
than one source port.
direction
Specifies the traffic to be mirrored from a source port to the
destination port. The options are:
receive: Copies the ingress packets on a source port.
transmit: Copies the egress packets on a source port.
both: Copies both the ingress and egress packets on a source
port.
Mode
Port Interface mode
Description
Use this command to create the port mirror or to add ports to the port
mirror. You must issue this command from the Port Interface mode of the
destination port of the port mirror. The switch can have only one
destination port.
Confirmation Command
“SHOW MIRROR” on page 464
To Next Page
Loading...
Need help?
General
