619
Chapter 41
LACP Commands
The LACP port trunk commands are summarized in Table 60 and
described in detail within the chapter.
Table 60. LACP Port Trunk Commands
Command Mode Description
“CHANNEL-GROUP” on page 620 Port Interface Creates new aggregators and adds
ports to existing aggregators.
“LACP SYSTEM-PRIORITY” on
page 622
Global
Configuration
Sets the LACP system priority value
for the switch.
“NO CHANNEL-GROUP” on
page 623
Port Interface Removes ports from aggregators and
deletes aggregators.
“PORT-CHANNEL LOAD-BALANCE”
on page 624
LACP Port
Trunk Interface
Sets the load distribution method.
“SHOW ETHERCHANNEL” on
page 626
Privileged Exec Displays the ports of the aggregators
on the switch.
“SHOW ETHERCHANNEL DETAIL”
on page 627
Privileged Exec Displays the states of the ports of the
aggregators.
“SHOW ETHERCHANNEL
SUMMARY” on page 629
Privileged Exec Displays detailed information about
the aggregators.
“SHOW LACP SYS-ID” on page 630 Privileged Exec Displays the LACP priority value and
MAC address of the switch.
“SHOW PORT ETHERCHANNEL” on
page 631
Privileged Exec Displays the LACP port information.
To Next Page
Loading...
