Allied Telesis AT-9000 Series - Show Auth-Mac Interface; Figure 165: SHOW AUTH-MAC INTERFACE Command

AT-9000 Switch Command Line User’s Guide
995
SHOW AUTH-MAC INTERFACE
Syntax
show auth-mac interface port
Parameters
port
Specifies a port. You can display more than one port at a time.
Modes
Privileged Exec mode
Description
Use this command to display the parameter settings of the authenticator
ports. This command is equivalent to “SHOW DOT1X INTERFACE” on
page 1000. An example is shown in Figure 165.
Figure 165. SHOW AUTH-MAC INTERFACE Command
Example
This example displays the parameter settings of authenticator ports 1.0.1
through 1.0.4:
awplus# show auth-mac interface port1.0.1-port1.0.4
Authentication Info for interface port1.0.2
portEnabled: Enabled - portControl: Auto
portStatus: UP
reAuthenticate: Disabled
reAuthPeriod: 3600
PAE: quietPeriod: 60 - maxReauthReq: 2 - txPeriod: 30
BE: suppTimeout: 30 - serverTimeout: 30
CD: adminControlledDirections: both
criticalVlan: Disabled
guestVlan: Disabled
dynamicVlanCreation: None
hostMode: Single-Host
dot1x: Enabled
protocolVersion: 1
authMac: Enabled
reAuthRelearning: Disabled