AT-9000 Switch Command Line User’s Guide
263
NO POWER-INLINE USAGE-THRESHOLD
Syntax
no power-inline usage-threshold
Parameters
None
Mode
Global Configuration mode
Description
Use this command to reset the power usage threshold to the default 80%.
The switch sends an SNMP power-inline trap if the power requirements of
the switch and PDs exceed the defined threshold.
Confirmation Command
“SHOW POWER-INLINE” on page 274
Example
This example restores the default power usage threshold of 80%:
awplus> enable
awplus# configure terminal
awplus(config)# no power-inline usage-threshold
To Next Page
Loading...
