AT-9000 Switch Command Line User’s Guide
967
AUTH DYNAMIC-VLAN-CREATION
Syntax
auth dynamic-vlan-creation
single| multi
Parameters
single
Single dynamic VLAN.
multi
Multiple dynamic VLAN.
Mode
Port Interface mode
Description
Use this command to dynamically assign a supplicant to a VLAN as
instructed by the RADIUS Server.
Use the NO AUTH DYNAMIC-VLAN-CREATION to disable this feature
(refer to “NO AUTH DYNAMIC-VLAN-CREATION” on page 990).
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 995 or “SHOW DOT1X
INTERFACE” on page 1000
Examples
This example activates single dynamic VLAN assignment on authenticator
port 1.0.18. When the initial supplicant logs on, the switch moves the port
to the VLAN specified in the supplicant’s account on the RADIUS server.
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.18
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth dynamic-vlan-creation single
To Next Page
Loading...
Need help?
General
