AT-9000 Switch Command Line User’s Guide
269
POWER-INLINE MAX
Syntax
power-inline max
max_power
Parameters
max_power
Specifies the maximum power limit of the ports in milliwatts (mW).
The range is 4000 to 30000 mW.
Mode
Port Interface mode
Description
Use this command to set the maximum power limits on the ports. The
maximum power limit is the maximum amount of power a port may
transmit to a PD. Ports can have different limits. The default power limits
are based on the classes of the PDs. See “Managing the Maximum Power
Limit on Ports” on page 250 for details.
Confirmation Commands
“SHOW POWER-INLINE” on page 274
“SHOW POWER-INLINE INTERFACE” on page 279
“SHOW POWER-INLINE INTERFACE DETAIL” on page 280
Example
This example sets the maximum power limits on ports 1 to port 6 to 6.5
watts:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.1-port1.0.6
awplus(config-if)# power-inline max 6500
To Next Page
Loading...
