1081
Chapter 68
sFlow Agent Commands
The sFlow agent commands are summarized in Table 93 and described in
detail within the chapter.
Table 93. sFlow Agent Commands
Command Mode Description
“NO SFLOW COLLECTOR IP” on
page 1082
Global
Configuration
Deletes the IP address of an sFlow
collector from the switch.
“NO SFLOW ENABLE” on page 1083 Global
Configuration
Disables the sFlow agent on the
switch.
“SFLOW COLLECTOR IP” on
page 1084
Global
Configuration
Adds the IP addresses and UDP ports
of sFlow collectors on your network to
the sFlow agent on the switch.
“SFLOW ENABLE” on page 1085 Global
Configuration
Activates the sFlow agent on the
switch.
“SFLOW POLLING-INTERVAL” on
page 1086
Port Interface Sets the polling intervals that control
the maximum amount of time
permitted between successive
pollings of the port packet counters by
the sFlow agent.
“SFLOW SAMPLING-RATE” on
page 1088
Port Interface Sets the sampling rates that
determine the number of ingress
packets from which one sample is
taken on a port.
“SHOW SFLOW” on page 1090 Global
Configuration
Displays the IP addresses and the
UDP ports of the sFlow collectors.
Also displays the sampling and polling
values for the individual ports.
To Next Page
Loading...
